- Make sure this fits by entering your model number.
- Ceiling Fan Switch Zing Ear 3 speed 4 wire pull chain switch replacment: Model ZE-268s6.
- Electrical Rating: 6A/125VAC,3A/250VAC.
- Three speed control: OFF,Low , Medium , High(OFF,L-1, L-2-3, L-3).
- Use for Ceiling Fans, Wall Lamps, Cabinet Light, Appliances, Replacement Speed Control.Works well in Hunter, Casablanca, Harbor Breeze, Hampton Bay and so on
- UL/CSA certification.100% Satisfaction guarantee,12-Month Warranty and 30 Days Money Back Guarantee. Any issue , please feel free to contact us and we are always at your service.
Features:
This ceiling fan is designed with 4 wires rotary control and 3 speed models.
Specification:
Function: Three speed control: OFF,Low , Medium , High(OFF,L-1, L-2-3, L-3)
Switch Type: Pull chain switch
Electrical rating: 6A/125VAC-3A/250VAC
Zing Ear ZE-268S6 (Replaces ZE-208S6) COMPATABLE WITH :
Hunter SW-A09
KTE3089T Circuit M
Sun-Lite SL-A-300
Jin You 4-hole switch (Black wire in terminal “L” and terminal number L-3-1-2 is in counterclockwise order)
Santa 4-hole switch (Black wire in terminal “L” and terminal number L-3-1-2 is in counterclockwise order)
Well Tec 3 speed 4-hole (Black wire in terminal “L” and terminal number L-3-1-2 is in counterclockwise order)
Shine Top 3 speed 4-hole (Black wire in terminal “L” and terminal number L-3-1-2 is in counterclockwise order)
Wu Pin 3 speed 4-hole (Black wire in terminal “L” and terminal number L-3-1-2 is in counterclockwise order)
Wu Pin LJY-288A E198635 4-hole (Black wire in terminal “L” and terminal number L-3-1-2 is in counterclockwise order)
Well Tec E116997 WTC-1 (terminal number L-3-1-2 is in counterclockwise order)
Shine Top LS-102 (Black wire in terminal “L” and terminal number L-3-1-2 is in counterclockwise order)
Note:
Disconnect the power to the fan before removing the old switch. Make sure to write down the position of all wires that you disconnect in the process of removing the switch. Do not cut wires from old switch, but remove by inserting blade of very small screwdriver next to wire and pulling out. Then insert the tinned wires in the same order as removed into the new switch.” (If you cut the wire you will lose the stiff tinned end and make it difficult to insert into the new switch unless you strip and re-tin it again with a soldering iron).